Class 3. Enameling steel mesh
Online
$200.00
$385, plus $65 kit
August 19-20, 2023
Day 1: 9 a.m. – 1 p.m. PDT—Instruction, demos, discussion and hands-on work. Day 2: 3-4 p.m. PDT—Troubleshooting, sharing work and discussion.
Note: Class 1 is a prerequisite.
Meshing around requires a little finesse. It’s the same with enameling on steel mesh. A gentle touch will improve your chances of success.
You will learn to:
- Incorporate enamel in design. Using enameling to enhance design of mesh pieces.
- Prepare. Preparing the steel mesh and liquid form enamels.
- Apply enamel to mesh. Application methods. Drying the enamel.
- Fire the enamel. Torch and kiln firing.
- Layer enameled mesh. Create added interest by layering enameled steel mesh.
- Mount enameled mesh. Combining it with sheet, wire and perforated steel sheet.
- Sealing it. Applying a wax sealer.
Skill level:
Students should be comfortable using a torch and should possess basic metal working skills, such as sawing, filing and forming. Some experience with enameling is beneficial but not required. Students should be knowledgeable about safe practices in a jewelry studio.
Kit:
$40 including shipping USPS flat rate envelope. The kit cost will be added when you register for the class. For U.S. students, kits will be shipped approximately at least one week before the class start. For non-U.S. students the timing and shipping cost will be based on location.
- 3 pieces of woven steel mesh 6” x 12”
- 1 piece of 20g steel sheet 6” x 12”
Student-provided supplies:
Note that the sources shown are merely examples. Many different vendors can be sourced for these products. In addition to the general list for tools and supplies needed for working with steel (see “Basic Tools and Supplies” PDF below), you will need to provide the following supplies, materials and tools for this class:
- Liquid form brushable opaque enamels—two or three colors—Thompson Enamel or Rio Grande (Note that a Ground Coat is not required)
- Paint brushes—two or three inexpensive smallish paint brushes from Michaels or any art supply store
- Particulate mask
- Small containers to mix liquid enamels
- Distilled water
- Heat gun or hair dryer--Amazon or hardware store
- Enameling trivet—Thompson Enamel
- Either gun bluing Oxpho Blue Brownells or Presto-black PC9 Sculpt Nouveau
- Your choice of clear Metal Wax from Sculpt NouveauOR Bowling Alley Wax from Amazon
- Optional but helpful
- Enameling kiln—enclosed kiln designed for enameling. Available from many different vendors. Manufacturers include Paragon, Vcella and Amaco.
- Firing fork—Thompson Enamel or Rio Grande
Basic Tools & Supplies
For supplies, materials and tools that you will need to provide for all classes, please refer to the basic list for tools and supplies needed for working with steel in the pdf below. As with the list of class-specific supplies (above), many of these are items that you may have on hand. Note that the sources shown are merely examples. Many different vendors can be sourced for these products.
Basic Tools and Supplies for Working with Steel »